Hello again.

Ive returned and i will start my build waay to late in to the summer.
Ive ordered new parts and id like to know yalls opinions
The parts:
Full Athena exhaust,
piston,
turn signals,
Plastics,
Pwk 36 carburetor,
Athena gaskets,
Bearings and bushings,
And a little paint.

Im planning to go full black on the plastics and put dark blue decals on them, also im going to paint the frame yamaha 403 dark blue.

Ive already upgraded my front suspention with dt 125 1980-1990 sumting motocross springs, heavier oil 15w, and put the stock spacer in my right fork. For the rear ive maxed out the shock and it rides lika dream even without the new parts yet.

The engine is in pretty good condition, all the gears are good but ive noticed that some bearings need to be replaced. I am very suprised that my crank is still good and not rattling beacuse ive used the bike for enduro/motocross/road usage. But my 3mb00 cylinder has a mirror finish and with my old piston has 75 psi but it still ripps and keeps up with a 2017 ktm sx 125 on full gas. Im sending the cylinder to my local shop to get it honed, then il run it with my old puston till the new parts arrive.

On the electrical side, everything is in meh condition. I need to rewire some parts and make some adjustments so i can put on my new turn signals. The biggest problem tha i have is that my derestrictor switch dosent work on the first try, i need to switch it for 30 seconds or so that it derestricts it and i have been thinking of putting somekind of a toggelable repeater on it so i dont have to mess with it, but i havent decided.

About the frame. It has some rust and dabage but mostly its all good, as a said before im thinking of spraying it with yamaha 403 dark blue paint, other than that im going to replace my swingarm bushings tomorrow, beacuse they are shot and rusted as hell.

For the drivetrain i bought a 15/51 sprokets so i can cruise at 90km/h in about 6000rpm and the top speed should be around 135km/h according to gearingcommander website.

Lastly i would like to ask, is there a way that i could increase my revs to about 11k rpm? Right now it maxxes at like 9.5k and dosent sound the best.

All the feedback is greatly appreciated.

DT125R FORUM

Mr Shadi