Thank you!. I want it to go back like factory.
T
Taran
@Taran
Posts
-
Wiring Harness Placement on a DT125X -
Yamaha Arm Relay | Rear Arm Help!!!Hello, I have had a re-bore to 57mm (PJME) and I have a full arrow exhaust. The carburettor is stock and is up jetted.(RRP Coventry) When I bought the bike a green/black wire has been cut and is connected to the frame via the radiator mounting bolt hole. I have had the bike dynoed (RRP Coventry) and on the power run it archived 23 WHP, ( I can show you the dyno printouts ) will the PCDI-10VT increase the BHP?
-
Yamaha Arm Relay | Rear Arm Help!!!@Calum Hi Calum, off topic. I was reading the Athena 170 thread and you mentioned that you would recommend the Zeeltronics. I have been looking into the PCDI-10VT, Would you recommend using the PCDI-10VT on a stock engine?
-
Yamaha Arm Relay | Rear Arm Help!!!Thank you both for the advice. I tried heat and a good tap, but no luck. I ended up cutting it off with an angle grinder. I have another one off a DT125x
-
Yamaha Arm Relay | Rear Arm Help!!!Hello,
I have completely stripped my Yamaha DT125 X down to frame. I need advice on how to remove the link between the rear arm and frame. the bolt spins around & the arm moves freely. I have tried everything, I have soaked it in ac-90 over night, heated it and used a drift to force it out. Nothing seems to move it. Can somebody please help?
