DT125R FORUM

The bike has been re wired properly following the hanes mauel im not new to bikes im just knew to this age of bike i think it will be my jets because who i bought it off of had everything cocked about with and all im tring to do is set it standered not make it a beast or a weapon jusy so everything is as it should. And the piston what was in it wasnt the best scratched to death along with the barrle so i changed it all to standered. The micrometre was for the piston not the barrle as its easy to messsure a piston to a barrle im well aware, ill be getting it sent off to someone who can set up my carb because that to me is the problem, when i started cleaning it all the af screw was jammed in and the idle screw all the way in inicating it ran like shit before for best words

@Calum hello my bad i was just needing some help as i dont normally post on forms, everythig for the top end is genuine and proper sizes i bought a micrometre to double check everything was sound and right, and ive been thinking about sending it to someone with more whit around them i just dont want to be ripped through the arse in the process because i does run just doesnt idle thats all anything below 3-4000 rpms the bike seems boggy, ive spoke had lots of advise from people on what it could be and it is slowly getting better

Hello im having a major problem with my dtr i got it needing a new top end rebuild and even with the horrible compression it had then it started and ran fine, after i rebuild the top end i noticed it wasnt idling right or it would only idle above 3000 rpm and when i try to turn the AF screw down its as if it does nothing, i replaced my left crank seal to make sure it wasnt that beofore i split any engine, and that helped a little it took the revs down a bit but still wont idle at 1500 it just dies or if i try give it throttle to bring it up it boggs out and dies, its been doing my nut in for past month or so and im clueless what it could be as everything got cleaned out properly and still doesnt want to idle. Any help would be much appreciated