DT125R FORUM

Well Iv used it on my dtr125 when I first got it because previous owners basically ran it to the ground but changed my spark plug,filter,oil etc and a general service after using it ok but yes ok for 2 strokes

@irongamer727 yes sea foam ok but what results are you wanting from using it ???

@fused thts what I was going todo today but can’t get in to it due to shock still been on the nut on shock rounded off so Iv been drilling it, banging, spraying with wd40 even heating it up now and then Iv been on with it for hours now not much further forward what a nightmare itis !!!!!

Mines also fully deresticted if you know how it’s easy lol

In my eyes the older dtr are the best ones to get upto 2003 as they stopped making them in 03 after then they are all wank mate thts my opinion anyway who needs electric start old school better than new any day, by the way my bike standard as they come cdi etc lol

Well Iv got a 2003 dtr 125 and it does 85 mph even though it’s only got 80 on clock lol it’s never been rebored just standard size Athena racing piston in, full dep pipe, drilled air box and carb upjetted runs really well through all the gears acceleration is very responsive and sounds like a crosser due to airbox drilled best dtr Iv been on and had over the years. Where you from ????

@finnerz89 il try tht in morning mate thx for input marra

Iv soaked and soaked it marra and also can’t turn bolt now due to me cutting both ends off today inside of frame using a electric saw so I guess il have to take shock off to give me a bit more room to see if I can get a grinder in I’m just worried I case a damage casing ??? Il have another Go tomorrow my head is farting hahaha

There’s nothing I haven’t tried it’s beat me hahahaha where could I heat on it ???

Yes sure did mate

Hi all I’m new on here I’m trying to take swinging arm off my 2003 dtr125 and the pivot is completely seized Iv been trying to take it off now for about 4 weeks, I’m absolutely done in with it, Iv tried everything so any suggestions anyone ???? Iv got another swingarm bolt etc to put straight on Iv tried cutting it today but can’t get in anywhere it’s stuck in the engine rollers by the looks of things as Iv managed to cut both ends off nearest to frame so any ideas ???