How do you wire a stator/magneto?

[GoProKid95]

Hi all,

I’ve identified my stator/magneto as dead. I’ve sourced a replacement unit, which has been removed from a working engine, however when it arrived the wiring is cut from the block connector.

I’ve still got the original so am familiar where the wires need to go, however three of them are solid white, so could they go to any of the three pins?

Thanks in advance,

Tom!

[SpookDog]

@goprokid95
Can you not jus trace them back on the original? Remove and replace the outer sleeve if needed...

[GoProKid95]

@spookdog Hi mate, the wiring is currently stripped right back on the replacement unit. I think I may have it sorta resolved now, gonna fit it tomorrow and see if it runs!