-
@glynn123 I would have used the DTR spindle and simply replaced the bearings in the wheels with ones that have a slightly bigger diameter and a spiggot ring if necessar.
Interested what you do with this, I know Shaunyboy on the old forum run R125 wheels. Ended up using Yamaha R125 brakes iirc but with stock dtx forks.
-
@calum Sadly the new shape MT/R125 rims have a smaller bearing outer than the older models, the bearings are both the same size front and rear, which is alot smaller than the standard DT one. It's gonna be a nightmare to setup but I'm excited to see the result.
-
Here's some pictures showing the axle comparison, aswell as my custom axle and the wheel mock fitted on the bike.
http://imgur.com/a/NLB31
-
-
-
@calum I reckon a good aluminium axle could stand the force no problem due to how it's clamped, however I'd be abit happier having it out some nice steel so will probably do that. I could do some calculations to work out the force put on the axle where the bearings sit. But It wouldn't account for jumps etc so not really relatable. One thing I know mind is that it wouldn't be fun losing the back wheel haha
-
-
There's been abit of reconsideration with the build, the rear end was going to be a nightmare, disc was so much out of line that a hub centric spacer would be needed, and one I got the opertunity of a pair of Dt hubs laced onto almost immaculate saxess rims with tyres and discs for £100 I couldn't turn it down haha. Pulled the new Michellin pilot street off the R125 rear wheel and swapped it onto the sm wheels, since the rear was on the limit anyways.
Will be updating the build as it goes, likely in another thread.
Cheers Glynn -
-
@calum yeah, basically my problem was starting the build too late in the winter, by the time I faffed about and got the forks done it was the end of January, my plans to have the bike on the road mid March and with the amount of manufacturing left to get the r125 wheels working, along with only being able to work on nights meant this likely wouldn't happen, and I am eager to have the bike on the road and well tested to do a memorial ride for a fallen rider early April.
I seen the bike which had used r125 wheels on here, looked like a very nice job, in fact it's on eBay right now with a couple days left and only at about £150
He used the older shape r125 wheels, which have different spacing and bigger outer bearing size, so I reckon a bigger bearing could be fitted to run the standard Dt axle. But basically the swap was a minefield of problems, and after doing the forks and many other bits on my bike I just wasn't in the mood for it this year, besides that the sm wheels I bought are in better condition and should be stronger.
