DT125R FORUM

Thanks for your replies
I put a rust-inhibiting primer on it, planning on using paint and a layer of clear coat afterwards. I hope it won't rust anytime soon

I found new informations, here are the essential tightening torques:
Float chamber screws: 2.0 Nm
Main jet: 2.0 Nm
Slide cover screws: 2.0Nm
Screw slide lever: 3.5Nm
Drain screw: 2.0Nm

carb housing gasket at https://www.gasketguru.co.uk/

Also i found the throttle-spring at http://www.motocarb.com/tm-parts.html

still looking for the nozzle assembly

@Calum

can you allow to edit posts, then I could reformat opening post and edit this infos? could be nice for others also looking for parts and stuff

Just found it out

The plunger has to be pulled down firmly

Then the parts are separated