dt 125x crankcase seal what way
-
Hi does anyone know the way the right-hand crankcase seal goes on a dt 125x,
is it with the spring to the inside of the crank or the outside.@Waggstar Is it a genuine seal? If so it should have "outside" written on it between the lip and the outer edge
-
@Waggstar Is it a genuine seal? If so it should have "outside" written on it between the lip and the outer edge
@HOTSHOT-III
No, its not a genuine one nothing on the seal saying, so should i have the spring side facing in. -
@HOTSHOT-III
No, its not a genuine one nothing on the seal saying, so should i have the spring side facing in.@Waggstar Just fished out a new genuine one and it actually has a garter spring on both seal lips!
The one marked "outside" has a thinner seal lip than the other side so I'd say orient the seal lip with more surface area towards the crankshaft.
Also had a look at one out of a Yambits seal kit which also has a garter spring on both lips but I can't see any difference between them so if it was me I think I'd be installing it with the writing on the outside (i.e facing away from the crankshaft).
-
@Waggstar Just fished out a new genuine one and it actually has a garter spring on both seal lips!
The one marked "outside" has a thinner seal lip than the other side so I'd say orient the seal lip with more surface area towards the crankshaft.
Also had a look at one out of a Yambits seal kit which also has a garter spring on both lips but I can't see any difference between them so if it was me I think I'd be installing it with the writing on the outside (i.e facing away from the crankshaft).
Thats just what il do cheers for the info, Hotshot
-
Thats just what il do cheers for the info, Hotshot
Just make sure that it’s in there nice and squarely. Also that the ‘insert’ has a good clean finish with no bad grooves or crud buildup on it

Did you split and rebuild the cases or just replace the seals? (both)...
Just use a proper clutch holder to tighten (or loosen) the clutch centre nut, don’t stick a screwdriver in the outer basket ‘fingers’! The alloy snaps so easy and without warning!...
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login