Coolant going to the expansion bottle
-
@Bananper Which end did you apply pressure. Obviously it protects from the radiator to the overflow, the other way around. Otherwise how would the water make its way back into the engine.
-
@Bananper Which end did you apply pressure. Obviously it protects from the radiator to the overflow, the other way around. Otherwise how would the water make its way back into the engine.
@Calum used this method https://youtu.be/QVQqqjkXjnA
-
@Calum used this method https://youtu.be/QVQqqjkXjnA
-
@Calum used this method https://youtu.be/QVQqqjkXjnA
-
@Bananper Besides, the spring preload isn't in that direction, It's in the opposite direction.
I don't know anything really about it, other than, when they go it will cause premature water to overflow.
-
If you change the head gasket, skim your cylinder head cause it's likely warped.
This can be done easily at home, get a glass chopping board and put some 1000 grit sandpaper on it, rub the head around it in a figure of 8 motion. If the heads really bad I usually use a oil stone first. Repeat while adding water to the wet and dry paper until whole head surface is even and shiny. Torque the head down, run the bike up to temperature, and then torque it down once again. -
@Bananper Go path of least resistance. I'd be inclined to change the radiator cap first, and then the head gasket.
-
@Calum ordered brand new radiator cap, but i have to wait for at least a week. Would it work to plug the line to the overflow so it does not fill up the bottle, just as a temporary fix?
Or will this cause big problems?
