1988 bike

[oldman]

[oldman]

Refurbed oil pump arrived back this morning, hard to believe it's almost 31 years old, perfect job!

Powdercoated spring collected yesterday as well, so can crack on a bit.

[oldman]

Reassembled shock ready for action

[Calum]

When I asked if the pump could be refurbished I was told it wasn't possible! I think he just didn't want the work!

[oldman]

Hes done all of mine, always come back like new, said there was loads of crud inside this one. Comes back with genuine Yamaha gasket and vent screw seals. Its peace of mind that I will not have to worry about it.

[NINJA]

@oldman Nothing beats some super shiny parts to bolt back on. :grinning_face_with_smiling_eyes: :winking_face: :grinning_face_with_smiling_eyes: :face_with_stuck-out_tongue_winking_eye:

[oldman]

Engine has entered the building!, shot blasted cases and 2 pack paint on side covers, wont even get my hands dirty fitting!

[NINJA]

@oldman Looks awesome dude, are the cases and head bare metal and did you spray the covers yourself???

[oldman]

@NINJA head prepared by me, sprayed and laquered, cases bare, side cases 2 pack professionally done

[oldman]

Oil pump side will be done again, paint reacting, bummer

[oldman]

Didn't notice until I put my widows on

[NINJA]

@oldman COOL - How much did the side cases cost to have done, if you don't mind me asking???

[declan]

@oldman that engine is the exact colour combination I’m wanting for mine

[oldman]

@NINJA not sure as cases blasted at same time, estimate around £70, does look good though

[NINJA]

@oldman That's not actually too bad for a quality job.

[oldman]

Progress today, engine in, clocks on and small jobs, looks a bit like a bike now

Pivot bearing sleeve ,bushes worn also, spare swingarm has been soaking in diesel most of the week, will try and remove bearings tomorrow without swearing, chances poor.

[oldman]

[declan]

@oldman mine are so much worser I’ve seen better condition metal on time team

[oldman]

Today I have been mostly refurbing carb. (Fast show joke, showing my age) came out all right but need to order new needle and tubes to finish, still not removed swing arm bearings, not that I am putting it off or anything!

[NINJA]

@oldman Looking good my friend. :clapping_hands_light_skin_tone: