Project I can't leave things alone!
-
So the yz rear wheel turn up today
It's 19 inch rather than the stock 18 inch dt wheel.
Looks like it's going to work great only thing I've noticed so far is the yz spindle is larger than the dt.
The calliper carry will need a little adjustment to make the new spindle fit.
-
@gareth_iowc Nice fat rubber you have their bud - looking good so far!!!
-
Got the new bolt for the dog bone to mount it to the frame from fowlers
Just waiting for the rear axle spindle to turn up so I can get the rear wheel fitted
-
Doh!! So the yz spindle is a lot shorter than the dt. So the next thing to try will be to see if I can take the dt wheel hub and fit it in the yz wheel with the yz spokes.
Thoughts?
-
@gareth_iowc This dude runs a wheel rebuilding service and has a good rep;
-
Thanks
only problem is I don't have Facebook lol.Might try a local bike shop as I've been told it's quite involved with getting it right.
-
@gareth_iowc No Facebook??? Dude your missing out. There are some wheel builders on ebay too.
-
@gareth_iowc Yeah wheel building is a dark art, so I am told.
-
Haven't posted in a while but things are still slowly moving .
The wheel has been with the builder for a week now so hoping to have it back soon.
Ordered the wrong front yz calliper doh!! So sending that back and ordering another. They calliper carry is wider on a 98 then the 97. My forks are 98
.The yz exhaust has arrived as well but I forgot to take a photo. It doesn't quite fit might need a little bit of heat and some bending to make it work but it's not to far off.
-
@gareth_iowc Took 6 months for the wheel builder to build my brothers YZ wheels!!!
-
Jesus 6 months! He's going to have them ready by end of next week
-
@gareth_iowc Nice big knobs - LOL
-
Yeah not sure what it's going to be like on road in the wet haha.
-
@gareth_iowc Just avoid any bends dude!!!
-
It's back!!! The wheel is finally back!!
So this is a 19" yz excel rim on a dt125r hub.
Fits nice even with the wheel pushed althe way towards the engine there's still clearance.
-
@gareth_iowc Looks factory fitted, nice job dude!!!
-
So the project isn't dead I've just been extremely busy with work.
Finally found a twin rad setup that works - https://www.ebay.co.uk/itm/252198042402
The bike is currently at the machine shop getting the engine brackets and radiator brackets made up.
And this arrived today
-
I was very happy with them when they arrived. Just needed to get some brackets made to fit nicely.
-
So this turned up today
