Swing arm movement
-
@kylescave Should still be able to get these parts from Yamaha
90387-164U8 - Part number for the collars
I'd grab genuine collars then get the bearings from SimplyBearings.co.uk
-
@Calum Okay sounds good, any chance you know the bearing size or can direct me to where i can find them? Many thanks.
@kylescave The bearings will have markings on them that you can use for reference. Simplybearings.co.uk will have them, that's where I got them from.
https://www.ebay.co.uk/itm/112551533577
But someone is selling them on eBay for £20
-
@kylescave The bearings will have markings on them that you can use for reference. Simplybearings.co.uk will have them, that's where I got them from.
https://www.ebay.co.uk/itm/112551533577
But someone is selling them on eBay for £20
-
@Calum Aren't those the swing arm bearings though? They are the ones I've replaced. Or is it possible that the linkage uses the same bearing.
@kylescave No sorry, they were the swinging arm bearings.
I vaguely remember doing them on mine. But I can't recall what the sizes were. Just press them out and get the part number from them
-
@kylescave No sorry, they were the swinging arm bearings.
I vaguely remember doing them on mine. But I can't recall what the sizes were. Just press them out and get the part number from them
-
Do a search for :
‘Yamaha DT125R rear suspension linkage repair kit’It’s not cheap (@ £110) but once done and properly maintained it should last forever. Nobody greases up the nipples on these! That’s why they fail...
-
I've collected all the parts to do the swingarm on my TDR (basically a DTR) from Yamaha / Wemoto and they were horrendously expensive. Bet its cost something daft like two hundred quid or even more for the 125 bits.
Strange then that All Balls make a kit for my DT200WR that includes everything across a couple of kits for around a hundred quid!
-
I've collected all the parts to do the swingarm on my TDR (basically a DTR) from Yamaha / Wemoto and they were horrendously expensive. Bet its cost something daft like two hundred quid or even more for the 125 bits.
Strange then that All Balls make a kit for my DT200WR that includes everything across a couple of kits for around a hundred quid!
-
Most stolen bike in the UK tax!...
If you checked the sizes I bet most bits are the same. The 200 does have an ally swing arm though, no?...
@SpookDog yes the 200wr has an aluminum swingarm but so does my 125r (got a dt200r one) and I bet you are correct that loads of bits are the same.
Oddly though the the 200 is narrower than the 125 with the linkage mount a different distance from the pivot so would not be a direct swap either
