Bike running fast revs
-
So new reeds installed carb boot looks to be installed right aswell as inlet manifold and the cable is loose and not binding snorkel is installed airbox is complete sounds like it’s running crazy lean but I’ve done nothing to cause this any ideas while I have a break?
-
-
-
-
@declan Oh dear.
Yes, take the air filter out.
Work from inside of the box outwards.
Use a soft spudger (dull flat edge NOT A SCREW DRIVER!!!!!) to prise the angle of it into the box.
Once you learn how to do it, it's easy.
Do not force it in. It will go in without hesitation once you have that technique down
-
-
-
-
@declan If it was working fine before hand, then it's going to be something properly simple. Rushing isn't going to fix the problem.
My guess is that it's an air leak, because this is the most common type of problem.
The inlet manifold gasket should be renewed. As said previously, these are prone to failure upon renewal.
You said your inlet had a split in it, have you replaced the inlet? Sounds like it's past its best and I would renew it with a new one whilsy Yamaha still make them...
-
-
-
-
