Yamaha Arm Relay | Rear Arm Help!!!
-
wrote on 23 May 2019, 18:05 last edited by Taran
Hello,
I have completely stripped my Yamaha DT125 X down to frame. I need advice on how to remove the link between the rear arm and frame. the bolt spins around & the arm moves freely. I have tried everything, I have soaked it in ac-90 over night, heated it and used a drift to force it out. Nothing seems to move it. Can somebody please help?
-
wrote on 23 May 2019, 21:44 last edited by
Get some heat on it and give a good tap with a bar it will come out
-
wrote on 24 May 2019, 07:33 last edited by
So common this.
You will need to just use lots of penetration fluid, heat and time and patience.
-
So common this.
You will need to just use lots of penetration fluid, heat and time and patience.
wrote on 11 Jun 2019, 19:36 last edited byThank you both for the advice. I tried heat and a good tap, but no luck. I ended up cutting it off with an angle grinder. I have another one off a DT125x
-
So common this.
You will need to just use lots of penetration fluid, heat and time and patience.
-
wrote on 11 Jun 2019, 20:07 last edited by
Yes I would
-
wrote on 12 Jun 2019, 09:18 last edited by
Hello, I have had a re-bore to 57mm (PJME) and I have a full arrow exhaust. The carburettor is stock and is up jetted.(RRP Coventry) When I bought the bike a green/black wire has been cut and is connected to the frame via the radiator mounting bolt hole. I have had the bike dynoed (RRP Coventry) and on the power run it archived 23 WHP, ( I can show you the dyno printouts ) will the PCDI-10VT increase the BHP?
-
wrote on 12 Jun 2019, 11:58 last edited by
A little bit off topic...but yes/no.
It may do, but what you'll really notice is the spread of power across the rev range.