Pinned pv sucks a**
-
@declan it probably closes as it picks up revs put it on a stand and rev it see if it closes before reopening
-
@terry-tz it was working soon as I plugged it in so you most likely right don't think it's a problem
-
@declan I would check as I have seen a thread on here where it was running backwards as it needed resetting or something like that
-
@terry-tz tyanks bud turns out the clip wasn't quite plugged in still lands open but when started it closed then opens back up when revved must have come loose while riding
-
@declan ye she runs good and healthy just don't sound like it with that pipe that spilled sparks all over a carriageway don't think there much wodding left in there hehehe
-
@terry-tz lol grab a dep new for 99 on eBay I'm painting my rad cowls white since the black was peeling
@declan if I buy a just the end pipe means I need to modify my front pipe because of the state of it and it has holes I jb welded so it really needs full pipe but we'll see if she sees me well il spend money on her at moment holding money back for if she gets ill
"Muddy water is best cleared by leaving it alone" Alan Watts
-
@declan if I buy a just the end pipe means I need to modify my front pipe because of the state of it and it has holes I jb welded so it really needs full pipe but we'll see if she sees me well il spend money on her at moment holding money back for if she gets ill
-
Something wrong with your bike if its not coming in until 8k lmao mine comes in at 6 and its not all that gutless before that either
-
Something wrong with your bike if its not coming in until 8k lmao mine comes in at 6 and its not all that gutless before that either
@andrewj1680 mine was terrible but with the valve it makes a lot of power
-
Something wrong with your bike if its not coming in until 8k lmao mine comes in at 6 and its not all that gutless before that either
@andrewj1680 said in Pinned pv sucks a**:
Something wrong with your bike if its not coming in until 8k lmao mine comes in at 6 and its not all that gutless before that either
Old DTR,s not the 88 3DB1 but all of the good ones G H J K reg etc that had no servo ride lovely with a pinned Powervalve and derestricted exhaust. Tough shit if you have a scrap DTR built between 1999 and 2003.
-
@andrewj1680 said in Pinned pv sucks a**:
Something wrong with your bike if its not coming in until 8k lmao mine comes in at 6 and its not all that gutless before that either
Old DTR,s not the 88 3DB1 but all of the good ones G H J K reg etc that had no servo ride lovely with a pinned Powervalve and derestricted exhaust. Tough shit if you have a scrap DTR built between 1999 and 2003.
@scrimsmustang mines a 1990
-
@scrimsmustang mines a 1990
@declan said in Pinned pv sucks a**:
@scrimsmustang mines a 1990
Should be sweet with a pinned powervalve then. My Black 90 has the pinned powervalve and it feels lots better than my 91 that I put a 3 wire servo kit on. You can feel the powerband better without the servo.
-
@declan said in Pinned pv sucks a**:
@scrimsmustang mines a 1990
Should be sweet with a pinned powervalve then. My Black 90 has the pinned powervalve and it feels lots better than my 91 that I put a 3 wire servo kit on. You can feel the powerband better without the servo.
@scrimsmustang this may be my fault I only disconnected the one wire and I think the valve was actually closed most of the time but either way I didn't like it
