pinned powervalve gap or no gap

[dan28]

but if the hole in the plastic pulley is aligned with the housing there is a gap between the pv an the cylinder wall
which way is correct
 

[Irongamer727]

@dan28 reupload the pictures.

[Calum]

@dan28 You need to wait for the upload to complete mate. What for the image to embed itself into the page before hitting submit Be paitient, you're working off a 2mb upload!

[dan28]

@calum said in pinned powervalve gap or no gap:

@dan28 You need to wait for the upload to complete mate. What for the image to embed itself into the page before hitting submit Be paitient, you're working off a 2mb upload!

Each time I try to upload its says the image is too large an doesn't embed it
Not sure why I m using the same phone an has worked on here before

[declan]

@dan28 so when you line the pv up like your supposed to inside the cylinder it’s restricting still? If so I recently discovered the same thing with mine so I set it before the hole

[declan]

@dan28 yeah it won’t work that way anymore

[Irongamer727]

@declan same for me

[declan]

@irongamer727 for the pv or pictures?

[Irongamer727]

@declan when aligned, the pv is not fully open.

[declan]

@irongamer727 yes my theory is it’s a cheeky restriction?

[Irongamer727]

@declan naah. It is clearly evident on my Athena 170. That's no restriction in that case

[declan]

@irongamer727 ooh wonder why it’s that way then?

[Calum]

I never go by the hole. Just match it with the exhaust port and away you go.

[dan28]

the plastic pulley has to aligned with hole to be able to pin it though unless I glue a washer on to the plastic pulley to align it before the hole