pinned powervalve gap or no gap
-
@dan28 You need to wait for the upload to complete mate. What for the image to embed itself into the page before hitting submit Be paitient, you're working off a 2mb upload!
wrote on 29 Dec 2017, 22:36 last edited by@calum said in pinned powervalve gap or no gap:
@dan28 You need to wait for the upload to complete mate. What for the image to embed itself into the page before hitting submit Be paitient, you're working off a 2mb upload!
Each time I try to upload its says the image is too large an doesn't embed it
Not sure why I m using the same phone an has worked on here before -
@calum said in pinned powervalve gap or no gap:
@dan28 You need to wait for the upload to complete mate. What for the image to embed itself into the page before hitting submit Be paitient, you're working off a 2mb upload!
Each time I try to upload its says the image is too large an doesn't embed it
Not sure why I m using the same phone an has worked on here before -
@calum said in pinned powervalve gap or no gap:
@dan28 You need to wait for the upload to complete mate. What for the image to embed itself into the page before hitting submit Be paitient, you're working off a 2mb upload!
Each time I try to upload its says the image is too large an doesn't embed it
Not sure why I m using the same phone an has worked on here before -
@dan28 so when you line the pv up like your supposed to inside the cylinder it’s restricting still? If so I recently discovered the same thing with mine so I set it before the hole
wrote on 30 Dec 2017, 11:13 last edited by@declan same for me
-
@declan same for me
wrote on 30 Dec 2017, 13:42 last edited by@irongamer727 for the pv or pictures?
-
@irongamer727 for the pv or pictures?
wrote on 30 Dec 2017, 15:08 last edited by@declan when aligned, the pv is not fully open.
-
@declan when aligned, the pv is not fully open.
wrote on 30 Dec 2017, 20:09 last edited by@irongamer727 yes my theory is it’s a cheeky restriction?
-
@irongamer727 yes my theory is it’s a cheeky restriction?
wrote on 30 Dec 2017, 20:36 last edited by@declan naah. It is clearly evident on my Athena 170. That's no restriction in that case
-
@declan naah. It is clearly evident on my Athena 170. That's no restriction in that case
wrote on 31 Dec 2017, 01:50 last edited by@irongamer727 ooh wonder why it’s that way then?
-
wrote on 31 Dec 2017, 10:17 last edited by
I never go by the hole. Just match it with the exhaust port and away you go.
-
wrote on 31 Dec 2017, 21:59 last edited by
the plastic pulley has to aligned with hole to be able to pin it though unless I glue a washer on to the plastic pulley to align it before the hole