DT200WR restoration project pic heavy
-
Can't stop taking pics, think I love doing this build more than the last one.
Need some more parts from fowlers, chain slide, chain guard, correct mud flap.
Exhaust front pipe needs a few small welds.
Front and rear brakes need tidying up
Side stand switch added,oil pump plumbed up, all wired up.
-
Some new bits came,
Cleaned up the forks and front wheel and indeed the new fork guards.New swing arm chain guard, chain guide and mudflap installed.
Fairings should be back from then bodywork shop next week.
Handguards installed and controls cleaned up.
-
@Louis-James Nice job and boy that kickstand looks MAAAAAAAAAAAHHHHHHHHHHOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOSSSSSSSSSSIIIIIIIIIIIIIIIVVVVVVVVVVVVVEEEEEEEEEEEEEEEEE!!!!!!! :grinning_face_with_smiling_eyes: :smiling_face_with_open_mouth_closed_eyes: :grinning_face_with_smiling_eyes:
-
@Louis-James anyone know much about fitting a battery? I just want to do a lights and PV test.. I think you can connect it to the loom r/s of flywheel
-
@Louis-James does it have the three white wires coming from the stator? You'd need them and a voltage regulator to convert the output from ac to dc.
-
So hopefully the main part of the project will be done this week.
Got the oil tank all set up nicely.
I had to extend one of the coolant hoses as was way too short.
This fairing bracket I ordered was no longer available so made one myself.As you can see the fuel tank is in amazing condition for age.. didn't even powdercoat it..
All the colours are colliding and making a nice 90s mess haha just as I wanted.
The fairings are ready to collect from the body shop
-
@Louis-James if its got the voltage reg already I should think it will. Probably have 3 white wires going to the vr and one red. The red is the 12v positive output that would go to the battery.
-
We'll here we are.... Fairings and graphics.
-
-
@Louis-James She looks lovely dude, where did you get the heat shield stuff from???
-
@Louis-James Do you have a link please bud???
-
@NINJA can't fit the exact listing but this is similar
https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F130796418818 -
@Louis-James OK Thanks, I ordered some from that dude before for my DTR, but the sheets were a bit on the small side. Good quality heat shield tho - nice and thick, I'll need some for my MX 125.
-
Well this was annoying.. normally wemoto is good but they sent the wrong brake lines... Says on the box dt200wr 3xp.
Will not fit. Even if routed differently.
Thinking about 1990-96 yz250 lines now
Got the calipers sand blasted and painted up.
Finally the clutch cable came
Only a few bits holding me up.
New chain rollers came.