Headstock bearings question

[declan]

@Calum I gotcha, but the cup moves if you touch it that said the cups new all the bearings are new there’s no play at all abs it’s smooth as butter I call this one good

[Calum]

@declan The race? No that should not move!

[declan]

@Calum yeah the race bud I’m leaving it for another day

[oldman]

Mine have all been hard to remove and secure when fitted, have you measured it against a known original. Will promote wear in frame seat if allowed to move even slightly

[declan]

@oldman I haven’t changed them they were already in the bike but they’re like new

[oldman]

But are they the correct size was my point, worth checking?

[declan]

@oldman it’s hard to say it looks like they were all changed together unless someone damaged one and had another lying around

[NINJA]

@declan How much is a new set? If in doubt it would be wise to replace them, if nothing more than just for peace_of_mind!!!

[declan]

@NINJA only 20 pound but a bit of a ball ache to install when I have the money I’ll buy a set and just swap the bearing race out probably after it’s built up and finished though

[NINJA]

@declan It would save you a lot of trouble in the long run and be a wise investment in your bike for-sure!!! :winking_face: :grinning_face_with_smiling_eyes: :winking_face: :face_with_stuck-out_tongue_winking_eye: