Missing oil pump nipple need help!

[Calum]

@declan New oil pump then is all I can say. Never seen thst before.

[declan]

@Calum

[declan]

@Calum do you know what the best pre mix ratio is for the dtr so I can make sure it actually works?

[Zrako]

Ehm. I see you only missing the pipe going from pump to intake and slacked cable...

[gareth_iowc]

How odd. Have you been self mixing up until now then?

[declan]

@gareth_iowc no when I got the bike it was set up but only 2mins after I got it the piston went so it's my first dt so I tore it apart and first start was earlier so I'm not familiar with it so now I'm running pre mix as I can't remember how that pipe had fitted on to there

[declan]

@Zrako cable is no longer slack that was an older pic are you saying there's no nipple for the pipe to slide on to
Then?

[andrewj1680]

The nipple is there its just the pipe has been cut if you look at it just take that bit of pipe off and replace it that 1 goes to the inlet

[Calum]

@andrewj1680 The nipple from the Oil Reservoir to the oil pump is missing.

[jgr72]

What is the inner diameter of the pipe that comes from 2t oil tank -> oil pump?

[declan]

@jgr72 around 5mm I think

[jgr72]

Okey, and is it the same 5mm from pump tu carb?

[Calum]

@jgr72 Nah, the hose from the oil tank to the oil pump is much larger.

[declan]

@jgr72 if I remember I'll look at my other bike it might have the size of pipe printed on it