YAMAHA DT 125 E SWISS
-
@DylanDT219 You need to check the crankcase serial number, which for a 91, will most likely be a 4BL - 000
-
@Darty mine is 3ME-0007 if you want i can send to you a photo
-
@DylanDT219 don't focus on 180 degree stuff. Whip the exhaust off and make sure the powervalve is flush with the exhaust port when the valve opens fully. To test the top end you can pin it open and disconnect the valve.
-
This post is deleted!
-
@Calum
okay let's say my valve is perfectly adjusted what should I do? change cdi? if so with which one? -
@DylanDT219 Make sure the inlet and exhaust tracts are free from restrictions. Ensure the linked above derestrictions are in place and make sure the engine is healthy.
Is the bike using stock gearing?
-
@Calum maybe you still have not understood the sport exhaust and it is no longer original I have mounted ujna firebox athena in addition to this on the site we wrote that inlet before 1991 there are no restrictions and then I do not know if the gearbox is original since I have never opened the engine and then I do not think that there are modified changes for the dtr
-
By restrictions mate, I mean blockages. Like is there leaves and dirt in the inlet tract. As well as exhaust. So yes it may be an aftermarket exhaust, but if it's blocked then that will cause poor performance.
And by stock gearing, I mean the front and rear sprockets.
Sorry for the confusion.
-
‘Lost in translation’ springs to mind...
How long has your bike been stuck at 80kph? (60 mph is slow and wrong)
Was it faster before? Has it always been so since tha 170 Athena kit? Did it come as a 170? More history is needed...Hazelnut brown is too dark, no?. Should be ‘tan’ ideally?? Been a while since I’ve had my last stroke (2)
️ -
@SpookDog my bike has always been blocked both with the original cylinder and with the 170cc it has always done less than 80 km / h. the 170cc arrived new from a german site with everything you need i still have the box ...
-
This post is deleted!
-
-
@SpookDog you rev up without problems, before I turned the YPVS by 180 ° it reached a maximum of 8 thousand rpm, but anyway this is the problem here someone has to tell me if they know any mechanical block so inside or outside the engine and electronically
-
-
me after making that post