Can get bike to run spraying starter fluid in spark plug hole but not with carb?
-
used a funnel and tube and poured premix in it started first kick with choke and ran and rev'd. So i guess it's the fuel tank? weird though because fuel would flow though the petcock out the tank on rev and on the fuel maybe fuel was not flowing very well? anyways just gonna order a new tank and hope it fixes the issue
-
@CYBER-NINJA the fuel line from pet cock to carb is ok. and tbh the tanks in terrible condition so most likely would be better to replace anyways as it's had a couple of welding jobs on it. When i brought it got it for a £100 as it was an insurance write off. So maybe theres a whole in the tank causing there to be no pressure in the petcock? but anyways it leaks fuel as well. i believe the dtr is a gravity fed petcock however so this is quite bizarre?!?!
-
@perithtv As @ricky0115 said
I would give the carb a clean and make sure none Of the jets are blocked and stick a new spark plug in!
By cleaning the carb you will get to see if there is any debris in it. If the tank is rusty inside it, this will contaminate the fuel, so that may well be the problem? I would start at the highest point Eg. The fuel tank - Is the petrol in the tank clean? Then check fuel lines, are any blocked?
Yes the fuel system is gravity fed, however it requires pressure from a sealed tank to allow fuel to be fed down into the carb. Therefore a rusty section or a hole in the tank from a bad weld could cause a loss of pressure.
Is the fuel coming out of the fuel cock clean? If they are all good, then I would look at the air pipe from the filter, does that have any holes or cracks? Is the air filter clean?
Is the fuel/air mixture correct? If it is out of balance that will cause bad starting problems. Check that the mixture screw is not faulty? Is the butterfly in the carb opening freely?
I would perform many checks before you go splashing the cash, as it may be just a cheap and simple fault causing the problems???
-
Theres no pressure in the tank, theres even vents in the fillercap to prevent it from happening.
-
on the right side of the tank under where the plastic attaches to the right side there is a pretty sizeable hole in the tank. so i put some jbweld on it and let it dry. then gave it a couple twist of the throttle as well as 3 priming kick. got top dead center and started first kick so i guess it the tank? i don't really feel like fixing this tank IE paintin it and all so i really do think it comes down to buying a new one
-
Is their a washer under your main jet if not that might be the problem