3rd piston ring please help

[declan]

Is it possible by not installing the wire ring that goes beneath the 2nd ring could cause the bike to lose compression resulting with extremely low power and not riding past 2nd?

[declan]

@Calum know anything bud?

[Calum]

I have never bothered to install them.

It really depends on the tolerances. It wouldn't pull in any gear if it was that much of an issje.

[declan]

@calum it's just really strange does my head in thanks for your time mate

[Calum]

Something isn't right if you are losing compression mate.

Are you sure this is what is happening?

[declan]

@calum not at all I've got it down to either fueling under load or weak spark under load as on the garden it's okay but if I take it out and select 2nd the bike comes to a stop at the end of the gear then after that it starts running weird like a splutter withough the noise if you know what I mean then I have to push it as it won't ride at all but will still run and rev

[Zrako]

@declan well , is your clutch set up properly? I mean the tension .

[Calum]

@zrako yeah, if it's losing power under load then it sounds like clutch is slipping.

[declan]

@calum the clutch was in a bad state but since I got a new lever and adjuster it will pop the front wheel up but it's losing the power after initially using the clutch it feels good but after then it's losing power I don't believe it to be the clutch but I really thought it was till I got a new lever the other day before that I could redline drop the clutch and barely move

[Zrako]

@declan is there plenty of free play on the lever?

[declan]

@zrako yes mate

[Calum]

Yeah but the load on the clutch in 1st is going to be minimal.

[declan]

@calum so what would you lean to will bad plates have this effect?

[Calum]

@declan Wouldn't be a bad place to start.

An idea would be to see if it pulls fine with no load on the engine.

So first just put the bike on a paddock, start it and go through all the gears. If that works no problems then jump on bike and od the same but keep it part throttle only. No load.

[declan]

@calum I've tried it with no load it works pretty much as it should

[Calum]

@declan With load on the engine does it revs hard and no power. Clutch is slipping then.

Either adjust it or replace it.

[declan]

@calum no it lacks power off the line when moving its decent shift into 3rd the revs die down to a slow idle and you go about 3mph

[Calum]

@declan Nah doesn't sound like clutch then.

Sounds like it's a carb setting.

Take the plug out and have a look.

Could simply just not getting enough fuel.

[declan]

@calum that's what I'm thinking as after I try hit 3rd and stop it feels starved not revving clean and real slow idle but sorts it's self out after a rest I've been doing some tests as it's got an open filter not the box as I have no rubber or filter for the air box but I haven noticed anything by restricting air flow

[Calum]

@declan Sounds like fueling to me mate.