Re lacing dt hubs to sm wheels

[declan]

@Calum nah I could build them then get them balanced for a tenna at a garage

[finnerz89]

@declan it's not the same as balancing after a new tyre mate

[declan]

@finnerz89 I know I mean tighten the spokes to balance the run out of the wheel

[Calum]

@declan It really isn't the same as balancing a tyre.

I don't want to go into too much detail, but it's a real delicate act.

The spokes must be tightened carefully and symmetrically as to not bend the rim. Then as you begin to torque each spoke up, you must in term the exact opposite spoke and work in a similar fashion as head bolts.

My knowledge is not the best on the subject, however I was under the impression that it was a dark art and best left to specialists.

[Jens Eskildsen]

I've done my own on my xt600, youtube have plenty of guides. Theres not much to it. Just like changing tires and overhauling and engine, its all about technique...

You wont bend a rim by tightening the spokes. You can make it go out of round for sure, but not bend it permanently.

declan is talking abot putting the parts together, and pay for the last steps where its trued. Sounds like a good way to save money. Any good bicycleshop can true the wheels aswell

[Calum]

Yeah that's cool.

As said I have no experience in this and was just under the impression it was something you would want a professional to do.

[declan]

@Jens-Eskildsen exactly that thank you.

[terry.tz]

i think i would do it myself to done bicycle wheels in the past and to be honest its the same shit tbh making the rig will be harder than doing the job the job is more time consuming as for balancing if your making the rig to do the job then you can balance the wheel you're self

[terry.tz]

This post is deleted!

[NINJA]

@declan Try this dude, he has a good rep and builds a lot of SuMo wheels;

https://www.facebook.com/paul.ritson.9?fref=ufi

https://www.facebook.com/sfxwheels/?ref=br_rs