Ypvs

[Calum]

I don't do it that way as I find it hit and miss.

Personally, take the exhaust off and make it flush with the port.

[jonne123]

So you align the cables when its flush and then tighten them so no slack?

[Calum]

But making sure that the powervalve is in a known state. It's no good aligning the powervalve to the port if it is midway through the cycle. as it'll be off as soon as you do a power cycle.

[jonne123]

What i have to do to sure that wont happen

[Calum]

Cycle the ignition system so it does the cleaning cycle.

[jonne123]

What do you think which way is better? https://youtu.be/obMy0adby8Y

[Calum]

Align flush with the exhaust port.

Any step in the exhaust port will disrupt the flow of gases.

As I have already said.

[jonne123]

I cannot make it flush with cables

[Calum]

How odd.

[declan]

@Calum reproduction cables maybe?

[Calum]

@declan I don't know mate, it's hard to say without actually being there to do it myself.

[DTlee]

Don’t you need to take the cables out and the black plastic part. Dont think you can do it by just adjusting the cables? Once you have the black plastic part out you can turn it by hand I think

[Calum]

You adjust the YPVS using the cables and threads to adjust it appropriately.

[DTlee]

Weird, I couldnt get enough adjustment just using the cables. So I took it apart and turned the power valve by hand so it was flush an put it back together and tightened the cable. Which I’m hoping has working alright. Haven’t got it quite ready to go on the road to test it yet though

[Calum]

@DTlee But that doesn't make sense? How could the cables reach otherwise?

[DTlee]

I had to flip the power valve 180 degrees, it’s not that the cables wouldn't reach but the adjustment on the screws wasn't enough to do it. Unless I majorly over complicated it for no reason?

[declan]

@DTlee yeah they doesn't make sense to me it should adjust with the cables no problem with plenty thread to spare sure your pv was in correctly?

[DTlee]

@declan maybe I was making a meal out of it then. Seems to have worked though

[jonne123]

My right side ypvs flap is lifting any solutions for that?

[Nottsbiker]

Take it apart, clean and refit with a new o-ring