PIC HEAVY (wr200 topend , zeeltronic, tm34ss carb, V-force reed block,Larger radiator,DEP PIPE,)
-
Old video to show previous work from the old forum
https://youtu.be/OPPg6yybNCoOld video of 200cc conversion
https://youtu.be/4arPAsoEZaEMore recent video.
More is constantly being done to this project
-
Old video to show previous work from the old forum
https://youtu.be/OPPg6yybNCoOld video of 200cc conversion
https://youtu.be/4arPAsoEZaEMore recent video.
More is constantly being done to this project
This post is deleted! -
This post is deleted!
-
This post is deleted!
-
This post is deleted!
-
Thanks guys, yes the zeeltronic is amazing. I was the one who helped zeeltronic make a cdi for the dt125r 2003 with my specs, data and wiring with the connector blocks pictures. Really helped set the correct powervalve curve and limits with my wr200 top end and using the dt125r stator plate, also the ignition timing.
-
Thanks guys, yes the zeeltronic is amazing. I was the one who helped zeeltronic make a cdi for the dt125r 2003 with my specs, data and wiring with the connector blocks pictures. Really helped set the correct powervalve curve and limits with my wr200 top end and using the dt125r stator plate, also the ignition timing.
-
@Louis-James I remember the commotion on the last site. Respect for that mate that's awesome.
@Calum thanks. I've seen yours too and it's sweet
-
This post is deleted!
-
The 200cc part
Crank cases bored to fit the wr200 crankshaft
Enlarging the transfer ports
Bought this off Gumtree, all threads stripped, I had to use a m10 helicoil kit on the head studs. The powervalve was damaged so I bought a brand new one at a later date. This is the nickasil bore version and didn't need a re-bore luckily so I bought a new wiseco piston and a brand-new wr200 crankshaft, originally I bought a wiseco yamaha blaster one which did fit in with modifications to the primary drive gear but I wasn't happy with it so I swapped it.
-
Bought this off Gumtree, all threads stripped, I had to use a m10 helicoil kit on the head studs. The powervalve was damaged so I bought a brand new one at a later date. This is the nickasil bore version and didn't need a re-bore luckily so I bought a new wiseco piston and a brand-new wr200 crankshaft, originally I bought a wiseco yamaha blaster one which did fit in with modifications to the primary drive gear but I wasn't happy with it so I swapped it.
A few comparison pics
The new piston
Powdercoated in my favorite colours
-
Old vs new haha
Née crank bearings
Test fit (I later had the crankcases sprayed)
-
Here's a close up of the wr200s boost ports (before I cleaned them) note: also bought a brand new powervalve afterwards as the dowl holes were sloppy.
Here's it built up (not using the tmx30 anymore)
-
My custom intake upgrade
Vforce v3 reed block - mikuni tm34ss carburetor
I cut the spigot off the reed block and centralized the flow to match the original and cut bolt holes to match
-
I cut off the flow guide from the manifold (this is not a restrictor, people think it is but it isn't, removing it will lose performance) I do not need this as my reed block comes with one fitted.
good job
