Autolube pvc see through pipe bubbles

[finnerz89]

You can bleed the pump, but if you're running premix as well you'll probably be fine.

[declan]

@sgt-robuck-5 yeah just take it for a ride it should sort it make sure your using autolube freindly oil

[Sgt Robuck 5]

@declan Will do tomorrow for a good 20mins

[Calum]

I wouldn't worry about it. So long as the bubbles move out and don't become bigger or more frequent in nature.

That's one of the perks for running clear tubing, you can see what's going on.

[Zrako]

As long as you dont have bubbles from oil tank to the pump it will be fine

[Jens Eskildsen]

What they said, just ride it

[Irongamer727]

Lending the thread a bit. As I have switched to clear oil lines, I am going to bleed the little sucker. My idea is, to speed things up, to disconnect the throttle cable running to the pump and manually open it fully. Thereby not having to wait forever and ever before the air is gone. Thoughts? Mind I have a brand new cylinder. (Of course running premix until bled)

[declan]

@irongamer727 just leave it as is it’s not a long process the revs help too it’s not all about throttle position

[Irongamer727]

@declan it's quite an easy undertake though. Should work.

[Jens Eskildsen]

You can open the pump without disconnecting the cable. Just push the pump open with a finger. All you need to do is remove the cover to the pump.

[Irongamer727]

@jens-eskildsen you think it would work?

[finnerz89]

@irongamer727 it's what the workshop manual says to do

[Irongamer727]

I am thinking of something like this. https://youtu.be/FytKDA4AqEE

[declan]

@irongamer727 yes using your finger will work but sometime it causes the Rev cable junction to screw up so you have to take your tank off and sort the cables out it happen everytime I do it it even sometimes throws the Rev cable out the carb

[Irongamer727]

@declan not an issue as the bike is already teared down after top end swap.

[declan]

@irongamer727 all good then

[Irongamer727]

@declan literally took 1 minute to "bleed". Didn't even bother to use the bleed screw. All good now u also running clear hoses?

[declan]

@irongamer727 from pump to manifold yeah when I have time I hope to change tank to pump as the hose is old and it’s pretty much plastic it’s that old it will crack if your not careful

[Irongamer727]

@declan allright, but why? As you already have a clear oil pipe from the pump, I don't see the benefits of having the entire feeder hose transparent?

[declan]

@irongamer727 like I said it’s old and brittle if it snags a branch and I don’t realise it will just crack it’s pretty much a ticking time bomb