Power valve
-
Not sure I'll check when I'll plug it all in and check when I'm home
-
Sorry to butt in the thread, but has anyone got any idea why... when I connected up a working servo to the plugs it was completely dead? No cleaning cycle whatsoever, cables not connected so no load on it. Just not working at all. What's the most likely causes? Could it be a CDI issue? (03 DTR) I want to put a servo on desperately. Cheers.
-
Mine was pinned when i bought the bike, reinstating the servo etc made a huge difference for me
@finnerz89 how did you manage to wire servo up pal
-
Or overtightened servo tensioners . I was setting them on and if they are not set properly , the servo will not reset when ignition turned on
@Zrako have you not had to rewire servo ?
-
@finnerz89 how did you manage to wire servo up pal
@ijohney123 just plug and play mate. My servo was unplugged with the cables overtightened so the pulley didn't move
-
Well I've took the servo and everything off made sure wasn't over tight then plugged back it but does the cleaning cycle really fast and doesn't move at all with the bike on any ideas
-
Well I've took the servo and everything off made sure wasn't over tight then plugged back it but does the cleaning cycle really fast and doesn't move at all with the bike on any ideas
@vtrn_raptor it won't move until you start to rev the bike mate. I think it starts to open up around 6000rpm
-
How manys wires is your servo
-
5 wires mate and it didn't budge at all even up to 7k
-
5 wires mate and it didn't budge at all even up to 7k
@vtrn_raptor servo dodgy ?
Do u have another cdi unit on yours to control it.? -
Yeah it's all connected to the cdi I've ordered a new servo see if that helps if not then it's the cdi
-
5 wires mate and it didn't budge at all even up to 7k
@vtrn_raptor Yeah it won't, I don't think it does at all in neutral.
It's easy to tell if the servo is operated as it will pull right through the rev range.
-
It doesn't move at all and the cleaning cycle is really erratic
-
It doesn't move at all and the cleaning cycle is really erratic
@vtrn_raptor Bad battery can do that. Also if it isn't setup the correct way, i.e. the cables the wrog way round.
-
The cables are the right way round I followed a Haynes manual the servos exactly the same without cables connected so ima try the new servo then battery if not either I'll replace the cdi bike was pinned via the servo and could be the reason it was pinned in the first place
-
Any news on this thread? Did the new servo sort it as mine does the same thing.
-
Any news on this thread? Did the new servo sort it as mine does the same thing.
