-
Spookdog thanks for the reply, I'm currently trying to suss this posting pics, I'll get some up when or if I can.
-
The coffin cover
knocked it up myself, used the existing screws holding the cylinder.
-
Looks smart I do love custom bits my brother made me some of these chain adjusters
So much nicer than the OEM steel ones
What do you think? -
Hi the honing looks not bad, having to reduce the quality of picture loses the clarity a lot.
Barrel I got from PJME waiting for rebuild…
It’s not easy getting the light right…
Actually, without a bit more definition it’s hard to tell. The real question is whether there’s a piston to fit your bore properly, or whether it’s going to be needing bore/honing again…
What does the slack measure?… -
I've been told the skirt is the spec area...its snug there, towards the top is the bigger gap due to cylinders being oval and because the heat is greater top end, therefore slightly greater space for expansion.
I've just ordered 2 o rings and 1 LH seal from Yambits, I might as well service the power valve whilst the cylinders off. Thanks for your info, its been a good first week on the forum.