DTR

[SpookDog]

@DTTOLATE

Download Imgur and use it to post/host the pic. Then copy the link and post it here using the 3rd icon from left in the toolbar…

[DTTOLATE]

Most of my stuffs in dropbox, if I copied a link would that do the trick?

[SpookDog]

@DTTOLATE
Don’t know what that is!
Try it
As long as it’s being hosted somewhere on the web

[DTTOLATE]

This post is deleted!

[MadGyver]

Welcome to the forum.It's nice to see the DTR team grow.

[DTTOLATE]

Thanks Madgyver, I'm hoping to learn more about the bike.

[DTTOLATE]

Cracked it....help yourself to a coconut.

[DTTOLATE]

Amazing what a sticker can do

[OllieDTR]

@DTTOLATE

Nice colour scheme mate, Is that aftermarket the rear master cylinder cover?

[DTTOLATE]

@OllieDTR

The coffin cover knocked it up myself, used the existing screws holding the cylinder.

[OllieDTR]

@DTTOLATE

Looks smart I do love custom bits my brother made me some of these chain adjusters
So much nicer than the OEM steel ones
What do you think?

[SpookDog]

@OllieDTR

Don’t know about him but I think you should send me a pair to test them out

[DTTOLATE]

@OllieDTR

They look the business, its those little details that draw the eye

[Calum]

Yeah the chain snails look smart, you can get aluminium ones on eBay for very little money. Needs the internal diameter reaming out mind you.

[DTTOLATE]

@SpookDog

Hi the honing looks not bad, having to reduce the quality of picture loses the clarity a lot.

[DTTOLATE]

@SpookDog

Forgeot to ask where's the best place to get the YPVS o rings/seals, I want to carry out a service on it whilst the barrels off.

[SpookDog]

@DTTOLATE

Barrel I got from PJME waiting for rebuild…

It’s not easy getting the light right…

Actually, without a bit more definition it’s hard to tell. The real question is whether there’s a piston to fit your bore properly, or whether it’s going to be needing bore/honing again…
What does the slack measure?…

[DTTOLATE]

@SpookDog

I've been told the skirt is the spec area...its snug there, towards the top is the bigger gap due to cylinders being oval and because the heat is greater top end, therefore slightly greater space for expansion.
I've just ordered 2 o rings and 1 LH seal from Yambits, I might as well service the power valve whilst the cylinders off. Thanks for your info, its been a good first week on the forum.

[SpookDog]

@DTTOLATE

Hey no problem, I’ve learnt that you can’t measure piston clearance with a feeler gauge! I never really looked into it before. I traditionally listen for the clatter 🥴

[OllieDTR]

@DTTOLATE

You’ll need a very accurate measurement of the bore top middle and bottom, you’ll need for this is a dial bore gauge, it’ll tell you the OD of the bore and tell you how round it is etc etc,

I send all my barrels and crank to Jim bailey (roadrunners) and he does it for me, I’ve been using him since 2017 for all my dts and mx bikes rm yz etc anything that has a steel liner which all mine was as they was sleeved, he’s very good and last time he did my dtr barrel I did 11k miles before stripping the bike for a restoration it still ran lovely.