DT200WR restoration project pic heavy
-
So today I did a test start to check all lights work.
Speedo and all lights on the new clocks work.
When I try the indicators....
the rear indicator stays on solid and the front does not light up , the clocks light stays on solid also...
This happens on both left and right hand side.
I think this is exactly what happened when my dtr relay went... Any thoughts? Hard to source the correct relay. -
So today I did a test start to check all lights work.
Speedo and all lights on the new clocks work.
When I try the indicators....
the rear indicator stays on solid and the front does not light up , the clocks light stays on solid also...
This happens on both left and right hand side.
I think this is exactly what happened when my dtr relay went... Any thoughts? Hard to source the correct relay. -
All the looming was Mint and I cleaned all connections. The neutral light goes off when in gear... I'm pretty sure it's the regulator issue I had on my dtr
-
@Louis-James Double check the wiring to make sure you haven't connected up the wrong sides. Sounds like a relay issue to me, I've had that a few times before.
@Calum that's what I think but it's a hard part to find. All earths were cleaned
-
What wattage lamps have you used in the indicators?
When I changed mine to higher wattage i got the same symptoms you're describing. -
@finnerz89 they're original ones but new
-
@Louis-James Check that the bulbs haven't gone and/or that the loom provides continutity throughout.
-
@Calum cheers call, seems a bit of a coincidence that it's both sides
-
If the lamps are standard my money is on the relay. Try disconnecting one and see if you get a flash then.
Is the switchgear new?@finnerz89 does a single flash then stats on.. always the small things take the time haha.
-
@finnerz89 does a single flash then stats on.. always the small things take the time haha.
-
@Louis-James another thought, is the light in the clocks led? Try disconnecting that if it is
@finnerz89 no because I'm only using the new clocks shell. All wires and bulbs I swapped over
-
@finnerz89 no because I'm only using the new clocks shell. All wires and bulbs I swapped over
-
-
@finnerz89 thanks
I'll get some more videos outside on a nice day
